💗DIY Scuba Neoprene Mini Skirt! So Cute - LOVE!💗 by E . 💗DIY Scuba Neoprene Mini Skirt! So Cute - LOVE!💗You need: at least 2 metres ( 2.5 yards) of scuba/neoprene fabric around 0.5cm thick (1/4 of an inch) craft paper a pencil super sharp scissors pins a sewing machine matching needle and thread (a sewing kit like this will have most of what you need to get started).How to: 1. Draw and up and then cut out this pattern onto craft paper. Note the pattern isn’t to scale as it will end up being bigger than A4.Just sketch it onto paper and make sure the dimensions are the same. You may also want to modify it slightly for length by adding a few cm/inches to the wider part of the template at the bottom.2. Work out how many pattern pieces you need. They are 10cm (4 inches) wide at the top (the part that goes around your waist) so what you need to do is work out how many panels you need to go around your waist. Remember you will lose some room when you sew the seams so if need be cut an extra one. I cut 8 but ended up only needing 7 when I sewed it all together. Cut your chosen number of rectables out of neoprene bigger than the template.3. Stack them together and pin the template on top. 4. Cut them out around the template. 5. Make sure to match the template carefully! 6. Placing the wrong side together, pin two pieces of neoprene together. 7. Pin the rest to the edges all the way around. 8. Sew all the edges together making sure to reinforce the beginning and end stitches. 9. 9. Sew the final panels together, you won’t need a zip because you should be able to get it over your head due to the stretch in the fabric. At this point you will want to check where it sits on your and perhaps add or remove panels, I ended up removing a panel and sewing the last seam together because I wanted it to sit high on my waist.Voila! (Love)! Thanks for looking!