DIY BEAD + CHAIN BRACELET by abc 🌞 def - Musely
  • Login/Sign up
  • $ 11% Cashback on all one-time purchases
    11% Cashback is available to all registered users and will be give in the form of Musely Coins.
    * Buy Together & Subscriptions orders are not eligible for Cashback
  • Free shipping over $25

    Free Shipping on All Orders Over $25.

    You may request a return within 30 days from the date the product is shipped.

    All returns may be tentative on brand approval.


posted in DIY & Crafts

beads – I used a selection from old necklaces
large curb chain
0.8mm wire
5mm jump-rings
vintage style jewelry clasps

    beads – I used a selection from old necklaces
    large curb chain
    0.8mm wire
    5mm jump-rings
    vintage style jewelry clasps
  • STEP 1
    Cut two lengths of chain, measuring the same width as your wrist plus 5 cm.

    STEP 2
    Cut lengths of wire of approximately 10 cm long. Fold over one end by a few millimeters and squeeze closed, forming little loops or ‘pin heads.’ I found it was easier to make a batch of these all at once.

    STEP 3:
    Now start to thread your beads. Leave two links of chain at the end of the bracelet, and then thread: bead, chain, bead, chain, bead. You can use all the same size beads if you prefer but I liked the contrast of sizes.

  • You will also need to make sure the holes of the outside beads are quite small so that the wire can’t pass through.

    STEP 4
    Once all the beads are in place, fold the end of the wire over the thinnest part of the pliers. You need the beads to be sitting really snug, and make sure the loop of the wire is as close as you can get to the last bead, to keep everything from moving around.

  • STEP 5
    Squeeze the loop together and snip off the excess wire.

    STEP 6
    Repeat the above steps until you have a full bracelet of beads making sure you stop two links from the end of the chain. You want to keep your beads as close together as possible. I tried to put a bead every two links but sometimes it got a bit bunchy so I had to do every three links. Keep an eye on bunching, and if you have to miss a link, do so.

    STEP 7
    Add your clasps to the ends of the bracelet, using 5mm jump rings. Each of these clasps has different holes. If there are two holes per clasp, then link either side of the

  • chain accordingly. If there is only one hole, first link your chain together forming a ‘triangle’ shape, then fasten to your clasp.

    STEP 8
    Make more bracelets – as soon as I made one, I had to give a few more variations a go!


See all comments

Related Tips

See other sign in/up options
Set up my password later
Login / sign up with Email
Forgot Password?
New to Musely
See other login options
Sign Up with Email
Already have an account? Login
Looks like you have an account already
Enter your password to proceed to checkout
Forgot Password?
Please re-enter your password
Forgot Password?
* This is for protection of your private information
Create a Password
For better protection, please provide a password for you account.
For privacy reasons, you must login every time you access this page.
Forgot Password?
< back
< back
Reset Password
Enter the email address associated with your account
< back